Share
The Ultimate Guide to Drying 3D Printer Filament
Because your printer deserves perfectly crisp filament — not a soggy, popping mess.
If you’ve ever heard your nozzle going “snap, crackle, pop” like breakfast cereal or watched your print turn into a stringy cobweb nightmare, then you’ve already met the #1 enemy of great 3D prints: moisture.
The good news? Defeating moisture is straightforward — and at Coex 3D, we win half the battle for you before the spool even leaves our facility in Green Bay, Wisconsin.
Let’s dive in.
Why Filament Absorbs Moisture (and Why It Matters)
Most 3D printing polymers are hygroscopic — they naturally attract and absorb ambient humidity. Leave a spool exposed for even a few hours in a humid environment, and it starts soaking up water like it’s on vacation.
Wet filament causes:
- Excessive stringing and oozing
- Brittle filament that snaps unexpectedly
- Bubbles, popping sounds from the nozzle, and surface defects
- Poor layer adhesion and weaker final parts
Bottom line: Dry filament prints better. Full stop.
How Coex 3D Delivers Moisture-Free Filament From Day One
We treat moisture like public enemy #1 — because it is.
Every Coex 3D spool is:
- ✔️ Thoroughly dried in an industrial oven immediately after extrusion
- ✔️ Vacuum-sealed within minutes of drying
- ✔️ Shipped with fresh, reusable desiccant packs
That means your filament arrives crisp, dry, and ready to print beautifully — unlike spools that have been sitting in humid warehouses for months.
Recommended Drying Temperatures & Times
If your spool has been exposed to air for a while (we’re looking at you, humid Wisconsin summers), give it a quick refresh using these proven settings:
Those silica gel packs we include with every order? They’re reusable superheroes.
80°C (176°F)
4–6 hours
Nylon / PA
80°C (176°F)
8–12 hours
TPU / TPE
50°C (122°F)
4–6 hours
HIPS
65°C (149°F)
2–4 hours
Pro tip: Always preheat your dryer, food dehydrator, or oven before putting the spool in. Sudden temperature jumps can warp spools in seconds.
Pro Hack: Recharge Your Desiccant Packs
To regenerate them:
- Spread the packets on a baking sheet
- Bake at 240°F (115°C) for 1–2 hours
- Let cool completely
- Return to your filament storage box
Free, unlimited moisture protection.
The Bottom Line
Dry filament delivers:
Prints to Impress
Start with filament that’s perfectly dry when it arrives.
Every spool from Coex 3D is dried, vacuum-sealed, and shipped with active desiccant.
Ready to deliver legendary results straight out of the box.
Share
Previous article
Let's Connect
Get in touch with your customers to provide them with better service. You can modify the form fields to gather more precise information.
Free shipping
Free delivery on filament orders over $75 (Contiguous US)
100% Satisfaction Guaranteed
If our filament does not perform as it should, we will replace or refund.
Top-notch support
As a US manufacturer, we are available to call and receive help.